MOTORCYCLE BATTERY METER HOW TO
MOTORCYCLE BATTERY METER FREE

Our goal is to charge your dead motorcycle battery and then see how well the battery can or can’t hold the charge. If your motorcycle battery has a pigtail installed, you can use the pigtail’s positive and negative terminals instead of having to access your battery itself. You’ll need access to the battery’s positive and negative terminals.Ī battery tender pigtail acts as a sort of two-way extension cord to help you get power to and from your motorcycle battery. On most motorcycles batteries are located under the seat, but they can also be found under the gas tank or under the air box. You’ll need to access your motorcycle’s battery in order to test it. Step 1: Access your battery or your battery tender pigtail They’re super cheap, super useful, and last a lifetime. It’s a great tool because you can use it for your motorcycle, home electrical, appliances You can use it for testing and troubleshooting everything from your home electrical to vehicles down to your home appliances. The first way is with a multimeter.Ī multimeter measures voltage (volts), current (amps), and resistance (ohms). There are two ways to test a dead motorcycle battery.

MOTORCYCLE BATTERY METER HOW TO

How to test a dead motorcycle battery with a multimeter

MOTORCYCLE BATTERY METER FREE

Battery tender pigtail (or free with battery tender).Motorcycle-specific battery tender (charger, comes with free pigtail).

In order to test your motorcycle battery and charging system you’ll need the following: Some quick links to help you navigate this document: In this article we’ll go over how you can tell whether you should recharge, or replace, your motorcycle battery, and how to test your charging system at the same time. But you also don’t want to recharge a bad motorcycle battery, take it for a ride, and end up stranded somewhere far from home. A good motorcycle battery can last you almost a decade. You don’t want to spend money on a new motorcycle battery if you don’t need to. If it reads under 12.4 volts or fails the test, replace the battery. Then, if the battery reads over 12.4 volts on the multimeter, or if it passes the battery load tester’s test you can keep it. First, charge the battery and wait 30 minutes. You can test a motorcycle battery with a multimeter or with a battery load tester.

Sometimes you’re better off replacing your motorcycle battery before it leaves you stranded again. Should you recharge or replace your dead motorcycle battery? Sometimes all your dead motorcycle needs is a quick recharge.

Motorcycle battery meter